Alcatel-Lucent OmniAccess 5740 - Ip Ospf Dead-Interval; Ip Ospf Flood-Reduction

Open Shortest Path First
Left running head:
Chapter name (automatic)
564
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP OSPF DEAD-INTERVAL
ip ospf dead-interval <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the number of seconds that a device must wait before it declares a neighbor
OSPF router down because it has not received a hello packet.
PARAMETERS
DEFAULT VALUE
Four times the hello-interval.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf dead-interval 50
IP OSPF FLOOD-REDUCTION
ip ospf flood-reduction
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to suppress the unnecessary flooding of LSAs in stable topologies.
PARAMETERS
None.
DEFAULT VALUE
Disabled.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf flood-reduction
Parameter Description
1-65535 Interval (in seconds) during which the router must receive at
least one hello packet from a neighbor or else that neighbor
is removed from the peer list and does not participate in
routing. The value must be the same for all nodes on the
network.