Alcatel-Lucent OmniAccess 5740 - Source-Nat Port-Range

source-nat port-range
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
675
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SOURCE-NAT PORT-RANGE
[<1-65535>] match [{all|any}] <match-list name> source-nat
port-range <2048-65535> <2048-65535>
DESCRIPTION
This command is entered in the NAT Configuration Mode. This command is used
to configure SNAT with a port range.
PARAMETERS
DEFAULT VALUE
If no port range is specified, a default port range of 2048 – 65535 is used.
EXAMPLE
ALU(config-nat-N1)# match m1 source-nat port-range 2048 6000
Parameter Description
1-65535 The range for the NAT policy rule. This rule number
signifies the priority of a rule.
match [{all|any}]
<match-list name>
match all - In this type of match, the relevant action is
performed only when all the match-list criteria is satisfied.
match any - In this type of match, the relevant action is
performed even if any one of the match-list criterion is
satisfied.
source-nat Type of NAT, here it is the SNAT.
2048-65535 The lower port number.
2048-65535 The upper port number.