EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Alcatel-Lucent OmniAccess 5740
1043 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #179 background imageLoading...
Page #179 background image
System Configuration and Monitoring
Left running head:
Chapter name (automatic)
144
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SNMP TRAP
snmp trap <ip-address> {v1|v2c} <community-string> <1-65536>}
vrf <vrf-name>
DESCRIPTION
This command is entered in the Configuration Mode. This command configures
the trap destination where the agent will send the SNMP traps.
Note: Cannot add more than 3 trap receivers.
PARAMETERS
EXAMPLE
ALU(config)# snmp trap 10.1.1.1 v1 trapcommunity 162
SNMP TRAP ENABLE
snmp trap enable
DESCRIPTION
This command is entered in the Configuration Mode. This command enables the
agent to send the SNMP traps to the configured host.
PARAMETERS
None.
EXAMPLE
ALU(config)# snmp trap enable
Parameter Description
ip-address The host IP address to which the trap
messages are to be sent.
{v1|v2c} SNMP version: v1/v2c
community-string SNMP v1/v2c community string.
1-65536 The notification host's UDP port number
vrf <vrf-name> Name of the VRF associated with the
interface through which the trap
messages are to be routed.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals