Alcatel-Lucent OmniAccess 5740 - Tunnel; Tunnel Bandwidth

tunnel
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
919
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
TUNNEL
tunnel Tunnel <0-14487>
DESCRIPTION
This command is entered in the Policy-map Mode. This command is used to
configure QoS over a tunnel interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-qos-P1)# tunnel Tunnel 1
TUNNEL BANDWIDTH
tunnel Tunnel <0-14487> bandwidth {<101-700000000>|percent
<1-100>}
DESCRIPTION
This command is entered in the Policy-map Mode. This command is used to
configure bandwidth for the tunnel interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-pmap)# tunnel tunnel1 bandwidth percent 10
Parameter Description
0-14487 Name of the tunnel interface with in the
specified range
Parameter Description
0-14487 Name of the tunnel interface.
101-700000000 The absolute bandwidth (bps) value.
1-100 The bandwidth in percentage.