Alcatel-Lucent OmniAccess 5740 - Class

Quality of Service
Left running head:
Chapter name (automatic)
886
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
CLASS
class {<class-map name>|<class-default>}
DESCRIPTION
This command is entered in the Policy-map Mode. This command is used to
configure a traffic class, i.e., associate a class map. Use keyword class-default to
configure the default traffic class to the policy map.
This command enters the Class sub-configuration mode inside the Policy-map
mode.
Note: If no rule is associated with a class-map and if you try to configure a class on that
class-map, a warning is displayed.
Example:
ALU (config-qos-P1)# class C1
No rule in class-map C1. It will not match any traffic.
PARAMETERS
DEFAULT VALUE
‘class-default’ is the default traffic class.
EXAMPLE
ALU(config-qos-P1)# class C1
ALU(config-qos-P1-C1)#
ALU(config-qos-P1-C1)# class class-default
ALU(config-qos-P1-class-default)#
Parameter Description
class-map name Name of the class map.
class-default Default traffic class.