Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

DHCP (Dynamic Host Configuration Protocol) Relay
Left running head:
Chapter name (automatic)
974
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP DHCP RELAY
ip dhcp relay <dhcp server ip-address>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to specify the DHCP server to which the DHCP requests are to be
forwarded. A maximum of four DHCP relay destinations can be configured per
interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip dhcp relay 192.168.1.1
IP DHCP RELAY INTERFACE
ip dhcp relay interface <interface-name>
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command is used to configure the interface through which the DHCP relay
requests have to be rebroadcasted.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip dhcp relay interface
GigabitEthernet 3/1
Parameter Description
dhcp server ip-address IP address of the DHCP server.
Parameter Description
interface-name The interface through which the DHCP relay
requests have to be rebroadcasted.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English