Multilink Frame Relay
Left running head:
Chapter name (automatic)
338
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW INTERFACES SERIAL
show interfaces Serial [<slot/port:channel>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. Use
this command to verify if MLFR is the current encapsulation on the interface, and
to check the interface details.
PARAMETERS
EXAMPLE
ALU# show interfaces Serial 0/0:1
Serial0/0:1 is up, line protocol is up
Internet address not set
MTU 1500 bytes, BW 1536 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation mlfr, MLFR Bundle Id: 1
Hello Interval: 10(secs)
Ack-interval :4(secs), Max Retry count :3
Link state : UP
Statistics:
Current Retry Count is 0
Add_link_sent:4, Add_link_rcvd:1
Add_link_ack_sent:1, Add_link_ack_rcvd:2
Rm_link_sent:0, Rm_link_rcvd:0
Rm_link_ack_sent:0, Rm_link_ack_rcvd:0
Hello_sent:55, Hello_rcvd:56
Hello_ack_sent:56, Hello_ack_rcvd:55
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0
drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1536 kilobits/sec
5 minute input rate 24 bits/sec, 0 packets/sec
5 minute output rate 24 bits/sec, 0 packets/sec
1237 packets input, 32681 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
1249 packets output, 49735 bytes, 0 underruns
0 output errors, 0 collisions, 16 interface resets
0 output buffer failures, 0 output buffers swapped out
18 carrier transitions
Timeslot(s) Used:1-24 (64Kbps each), Transmitter delay is 0 flags
Parameter Description
slot/port:channel Slot and port number and channel group
number of the interface.
To Next Page
Loading...
Need help?
General
