firewall policy {in|out}
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
713
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
FIREWALL POLICY {IN|OUT}
firewall policy {in|out} <policy-name>
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command is used to attach a firewall policy to an interface in ‘in’ or ‘out’
direction. Firewall policy is applied to the ingress (incoming) traffic if “in” keyword
is used. Firewall policy is applied to the egress (outgoing) traffic if “out” keyword is
used.
Note: Firewall policy will not take effect until it is bound to an interface.
PARAMETERS
DEFAULT VALUE
No default parameters.
EXAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# firewall policy in P1
ICMP-BLOCK-TRACE-ROUTE
icmp-block-trace-route
DESCRIPTION
This command is entered in the Firewall-Attack Sub Configuration Mode. This
command is not a default attack setting. This is not set for protection by default on
the OmniAccess 5740 USG, but you can turn it on by explicitly adding the above
command in the user-defined attack prevention list.
PARAMETERS
None.
EXAMPLE
ALU(config-firewall-attack-A1)# icmp-block-trace-route
Parameter Description
in Firewall policy is attached to the ingress traffic.
out Firewall policy is attached to the egress traffic.
policy-name Name of the firewall policy.
To Next Page
Loading...
Need help?
General
