ppp ipcp address pool local
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
297
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
PPP IPCP ADDRESS POOL LOCAL
ppp ipcp address pool local <ip-address>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
enables you to configure an IP address pool for IPCP to give an IP address to its
peer.
PARAMETERS
DEFAULT VALUE
By default, no IP address pool is configured for IPCP.
EXAMPLE
ALU(config-if Serial0/0:0)# ppp ipcp address pool local
10.10.10.10
Note: On a PPPoE enabled interface, ‘ppp ipcp address pool local <ip-address>’ should not
be configured as the interface is always in PPPoE client mode.
PPP IPCP NEGOTIATE
ppp ipcp negotiate
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to initiate the IPCP negotiation on the interface.
PARAMETERS
None.
DEFAULT VALUE
By default, the OmniAccess 5740 USG responds to IPCP negotiation initiated by
the peer. Auto-negotiation happens when the IP address is changed on the
interface.
EXAMPLE
ALU(config-if Serial1/0:0)# ppp ipcp negotiate
Parameter Description
ip-address IP address to be given to the peer.
To Next Page
Loading...
Need help?
General
