ppp lcp max-echo
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
299
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
PPP LCP MAX-ECHO
ppp lcp max-echo <0-30>
DESCRIPTION
The command is used in the Interface Configuration Mode. This command
denotes the maximum number of unanswered LCP echo requests sent before
LCP decides that the peer is down. The value “0” implies that the link will not be
brought down on the basis of unanswered echo requests.
PARAMETERS
DEFAULT VALUE
The “no” command sets the maximum number of unanswered LCP echo requests
to is default, i.e., 5.
EXAMPLE
ALU(config-if Serial0/0:0)# ppp lcp max-echo 20
PPP TIMEOUT RESTART-INTERVAL
ppp timeout restart-interval <0-255>
DESCRIPTION
The command is used in the Interface Configuration Mode. This command
defines the interval after which the LCP/NCP negotiation will be reattempted after
it is terminated.
PARAMETERS
DEFAULT VALUE
The default LCP/NCP restart-interval is 30 seconds.
EXAMPLE
ALU(config-if Serial0/0:0)# ppp timeout restart-interval 10
Parameter Description
0-30 Denotes the maximum number of unanswered
requests.
Parameter Description
0-255 Specifies the interval after which the LCP
negotiation will be reattempted after it is
terminated.
To Next Page
Loading...
Need help?
General
