Alcatel-Lucent OmniAccess 5740 - Telnet

System Configuration and Monitoring
Left running head:
Chapter name (automatic)
150
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
TELNET
telnet [vrf <vrf-name>] {<ip-address>|<hostname>}
DESCRIPTION
This command is entered in the Configuration Mode. This command starts a telnet
connection to a remote computer.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU> telnet 10.91.0.1
RELEASE HISTORY
Release 2.3: parameter vrf <vrf-name> was added.
Parameter Description
vrf-name If the VRF name is specified, the packets
will be routed using the routing table of
the specified VRF on a interface
associated with the VRF.
ip address IP address of the remote host.
hostname Host name of the remote host.