Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

T1E1 Line Card
Left running head:
Chapter name (automatic)
254
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
FRAMING
framing {esf|sf}
DESCRIPTION
This command is entered in the Controller Configuration Mode. This command is
used to configure framing type. The service provider determines which framing
type, either sf or esf is required for your T1 circuit.
PARAMETERS
DEFAULT VALUE
The default framing on T1 line is esf.
EXAMPLE
ALU(config-controller T1)#framing sf
INTERFACE SERIAL
interface serial <slot/port:channel>
DESCRIPTION
This command is entered in the Interface Configuration Mode to configure a serial
interface.
PARAMETERS
EXAMPLE
The following example creates an interface at slot 0 and port 0 at channel group 0:
ALU(config)#interface Serial0/0:0
ALU(config-if Serial0/0:0)#
Parameter Description
esf Extended super frame is the T1 frame type.
sf Super frame is the T1 frame type.
Parameter Description
slot Specifies the slot location.
port Specifies the port number.
channel Specifies the channel number.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English