Alcatel-Lucent OmniAccess 5740 - Crypto Client Profile

IP Security - Virtual Private Network
Left running head:
Chapter name (automatic)
830
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
CRYPTO CLIENT PROFILE
crypto client profile <name>
DESCRIPTION
This command when entered in the Configuration Mode is used to configure a
new crypto client profile. Following are the default values for a newly configured
crypto client profile:
• Default IKE policy in a client profile: ‘default’ IKE policy
• Default transform set: ‘default’ transform set
• Default PFS group: pfs group2.
• Default IPsec security-association lifetime in seconds: 28800
This command when entered in the Interface Configuration Mode is used to attach
a configured client profile to an interface. You can attach only one client profile on
an interface and vice versa.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# crypto client profile myclientprofile
ALU(config-client-prof-myclientprofile)#
ALU(config-if GigabitEthernet3/0)# crypto client profile
myclientprofile
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
name Name of the IPsec client profile.