Alcatel-Lucent OmniAccess 5740 - Dot1 X Re-Authenticate Interface Switchport; Dot1 X System-Auth-Control

dot1x re-authenticate interface switchport
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
219
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
DOT1X RE-AUTHENTICATE INTERFACE SWITCHPORT
dot1x re-authenticate interface switchport <slot/port>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
manually reauthenticate the clients connected to a port.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)# dot1x re-authenticate interface switchport 5/0
DOT1X SYSTEM-AUTH-CONTROL
dot1x system-auth-control
DESCRIPTION
This command is entered in the Configuration Mode.This command is used to
enable 802.1X port-based authentication globally.
PARAMETERS
None.
DEFAULT VALUE
When enabled, the port-based authentication on the interface will be ‘forced-
authorized’.
EXAMPLE
ALU(config)# dot1x system-auth-control
Parameter Description
slot/port Interface slot and port number.