card type
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
249
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CARD TYPE
card type {E1|T1} <slot>
DESCRIPTION
This command is entered in the Configuration Mode to set the card type of T1
controller in a specific slot.
PARAMETERS
DEFAULT VALUE
By default, no card type is installed.
EXAMPLE
The following example sets the card type of T1 controller:
ALU(config)# card type T1 0
Note: The line card is not functional until card type is set. Reboot/Reload the chassis to
change the card type, which will remove the previous configuration. Use controller
and channel-group commands to relaod the card type.
Parameter Description
E1|T1 Sets the card type to E1 or T1.
Use T1 keyword to set the card type
to T1.
slot Enter the specified slot number.
To Next Page
Loading...
