Alcatel-Lucent OmniAccess 5740 - Interface Tunnel; Ip Address

interface tunnel
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
805
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
INTERFACE TUNNEL
interface Tunnel <0-14487>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure a tunnel interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)# interface Tunnel 1
ALU(config-if Tunnel1)#
IP ADDRESS
ip address {<ip-address subnet-mask>|<ip-address/prefix-
length>}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to assign an IP address and subnet mask to the tunnel interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if Tunnel1)# ip address 20.20.20.20/24
Parameter Description
0-14487 The number specified for the tunnel.
Parameter Description
{<ip-address subnet-
mask>|<ip-address/prefix-
length>}
IP address with subnet mask or prefix
length.