Alcatel-Lucent OmniAccess 5740 - Match-Lists (Rulesets)

Common Classifiers
Left running head:
Chapter name (automatic)
406
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
MATCH-LISTS (RULESETS)
This command is entered in the Match-list Configuration Mode. The following
command is used to configure rules for IP in a match-list:
[<1-1024>] ip {any|host <source ip-address>|interface
<name>|list <name>|prefix <source ip-address/prefix length>}
{any|host <destination ip-address>|interface <name>|list
<name>|prefix <destination ip-address/prefix length>} [dscp
{<0-63>|<dscp-mnemonics>}|fragment|ip-precedence {<0-
7>|<precedence-mnemonics>}|length {<1-1500>|{eq|ge|gt
|le|lt|range <1-1500>}}|tos {<0-15>|<tos-mnemonics>}]
This command is entered in the Match-list Configuration Mode. The following
command is used to configure rules for TCP in a match-list:
[<1-1024>] tcp {any|host <
source ip-address>|interface
<name>|list <name>|prefix <source ip-address/prefix length>}
{any|host <destination ip-address>|interface <name>|list
<name>|prefix <destination ip-address/prefix length>}
[ack|dscp {<0-63>|<dscp-mnemonics>}|established|fin|
fragment|from <1-65536>|ip-precedence {<0-7>|<precedence-
mnemonics>}|length {<1-1500> |{eq|ge|gt|le|lt|range <1-
1500>}} |rst|service {<1-65536>|<protocol>}|syn|urg|tos {<0-
15>|<tos-mnemonics>
}|type {ftp|normal|rpc|rtcp|rtp|sip
|tftp}]
This command is entered in the Match-list Configuration Mode. The following
command is used to configure rules for UDP in a match-list:
[<1-1024>] udp {any|host <source ip-address>|interface
<name>|list <name>|prefix <source ip-address/prefix length>}
{any|host <destination ip-address>|interface <name>|list
<name>|prefix <destination ip-address/prefix length>} [dscp
{<0-63>|<dscp-mnemonics>}|fragment|from <1-65536>|ip-
precedence {<0-7>|<precedence-mnemonics>}|length {<1-
1500>|{eq|
ge|gt|le|lt|range <1-1500>}}|service {<1-65536>
|<protocol>}|tos {<0-15>|<tos-mnemonics>}|type {ftp
|normal|rpc|rtcp|rtp|sip|tftp}]