Alcatel-Lucent OmniAccess 5740 - Eth-Cfm Eth-Test

Ethernet OAM (Operations, Administration, and Maintenance)
Left running head:
Chapter name (automatic)
348
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ETH-CFM ETH-TEST
eth-cfm eth-test <mac-address> mep <1-8191> domain <0-65535>
association <0-65535> [{datasize <1-1480>|priority <0-7>}]
DESCRIPTION
This is entered in the OAM Configuration Mode. This command is used to initiate
an Ethernet test signal.
PARAMETERS
DEFAULT VALUE
By default, Ethernet test is disabled.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-oam)# eth-cfm eth-test 1111.1111.1111 mep 10 domain
1 association 10 priority 2
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
mac-address MAC address given on the interface.
1-8191 An integer, unique over a given MA,
identifying a specific MEP.
0-65535 An unique integer identifying a specific
maintenance domain.
0-65535 An unique integer identifying a specific
maintenance association.
1-1480 Specifies the size of data (in bytes) to be
sent as a part of the Ethernet test.
0-7 Value set for CCM and LTMs on a MEP.