EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Alcatel-Lucent OmniAccess 5740
1043 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #290 background imageLoading...
Page #290 background image
linecode
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
255
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
LINECODE
linecode {ami|b8zs}
DESCRIPTION
This command is entered in the Controller Configuration Mode. Use this
command to configure the line-code type for a T1 line. The T1 service provider
determines which line-code type, ami or b8zs, is required for your T1 circuit.
PARAMETERS
DEFAULT VALUE
The default linecode value is b8zs.
EXAMPLE
The following example specifies AMI as the linecode type for a T1 line:
ALU(config-controller T1)# linecode ami
Parameter Description
ami Alternate Mark Inversion (AMI) line-code type.
Note: If ‘ami’ linecode is configured, configure
timeslot speed to 56Kbps to ensure 1st
density.
b8zs b8zs line-code type.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals