Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Point to Point Protocol
Left running head:
Chapter name (automatic)
290
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ENCAPSULATION PPP
encapsulation ppp
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the PPP encapsulation on an interface.
PARAMETERS
None.
DEFAULT VALUE
The default encapsulation on a serial interface is HDLC.
EXAMPLE
ALU(config)# interface Serial1/0:0
ALU(config-if Serial1/0:0)# encapsulation ppp
NO DEBUG PPP
no debug ppp {echo|all}
This command is entered in the Super User Mode or Configuration Mode. The
“no” command disables the debug functionality. By default, debug is disabled.
NO ENCAPSULATION PPP
no encapsulation ppp
This command is entered in the Interface Configuration Mode. This command
sets the encapsulation to its default, HDLC.
NO PPP AUTHENTICATION
no ppp authentication
This command is entered in the Interface Configuration Mode. The “no” command
removes the authentication protocol for authenticating the peer.
NO PPP AUTHENTICATION CLIENT-PASSWORD
no ppp authentication client-password
This command is entered in the Interface Configuration Mode. The “no” command
deletes the configured authentication password on the client side.
NO PPP AUTHENTICATION CLIENT-USERNAME
no ppp authentication client-username
This command is entered in the Interface Configuration Mode. The “no” command
deletes the configured authentication user name on the client side.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English