mode
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
807
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
MODE
mode {gre|ipsec}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to set the mode on tunnel interface.
PARAMETERS
DEFAULT VALUE
By default, tunnel is configured in GRE mode.
EXAMPLE
ALU(config-if Tunnel1)# mode ipsec
NO IKE-IDENTITY
no ike-identity
This command is entered in the IPsec Profile Configuration Mode. The ‘no’
command detaches the specified IKE identity attached to a profile.
NO IKE-POLICY
no ike-policy
This command is entered in the IPsec Profile Configuration Mode. The ‘no’
command detaches the specified IKE policy attached to the profile. An IKE policy
must be first detached from the profile to delete it globally.
NO IPSEC-PROFILE
no ipsec-profile <profile-name>
This command is entered in the Interface Configuration Mode. This command is
used to detach the IPsec profile attached to the interface. You cannot delete an
IPsec profile that is applied to the interface. To delete, first detach the IPsec profile
from the tunnel interface.
Parameter Description
gre Use this keyword to configure the tunnel
in GRE mode.
ipsec Use this keyword to configure the tunnel
in IPsec mode.