Alcatel-Lucent OmniAccess 5740 - Fault-Alarm Set-Time

fault-alarm set-time
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
355
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
FAULT-ALARM SET-TIME
fault-alarm set-time <250-1000>
DESCRIPTION
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to specify the time interval (in milliseconds) after which the fault
alarm is raised for all the defects detected for a MEP.
PARAMETERS
DEFAULT VALUE
The default time interval is 250 milliseconds.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-oam-domain-assoc-mep)# fault-alarm set-time 300
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
250-1000 Specify the time interval (in milliseconds)
in the range 250-1000.