Alcatel-Lucent OmniAccess 5740 - Show Interface Serial

show interface serial
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
395
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SHOW INTERFACE SERIAL
show interface serial <slot/port>
DESCRIPTION
This command is entered in the Super User Mode, Configuration Mode or
Interface Configuration Mode. This command displays the configured value of
fragment size and slippage MRU configured on the specified interface.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# show interface Serial0/0:0
Serial1/0:0 is up, line protocol is up
Internet address is 3.3.3.2/24
MTU 1500 bytes, BW 1536 Kbit, DLY 0 usec,
Fragment-size 80, slippage mru 16
reliability 255/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation frame-relay, keepalive not set
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 0 LMI type is Autosense frame relay DTE
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0 drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1536 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1-24 (64Kbps each), Transmitter delay is 0 flags
RELEASE HISTORY
Release 2.3: command was modified.
Parameter Description
slot/port Slot and port number of the interface.