Alcatel-Lucent OmniAccess 5740 - Page 74

Configuring Interfaces
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
39
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
BACKUP INTERFACE
TO CONFIGURE A BACKUP INTERFACE
EXAMPLE
ALU(config-if GigabitEthernet3/0)# backup interface Serial1/0:0
ALU(config-if GigabitEthernet3/0)# no backup interface Serial1/
0:0
T
O VIEW BACKUP INTERFACE DETAILS
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# show
GigabitEthernet3/0 is up, line protocol is up
Hardware is Intel 82546, address is 0011.8b00.2712 (0011.8b00.2712)
Internet address not set
/*Interface Serial1/0:0 is backup interface*/
MTU 1500 bytes, BW 10000 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation ARPA, keepalive not set
Auto-duplex(Half), Auto(10), 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0 (size/max), 0 drops; Input queue 0/0 (size/max), 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
10 packets input, 7468 bytes, 0 no buffer
Received 7 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 packets output, 0 bytes, 0 underruns
Command (in ICM) Description
backup interface <interface-
name>
Enter this command in the Interface
Configuration mode.
This command is used to configure an
interface as a backup interface.
no backup interface
<interface-name>
This command is used to remove an
interface as a backup interface.
Command (in ICM) Description
show This command displays the information
of the backup interface.