OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Left running head:
Chapter name (automatic)
4
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PART IV - PACKET CLASSIFICATION
This part consists of Chapter 22 “Common Classifiers” that focuses on
Common Classifier commands. These commands are generic across all
applications. You are required to have a thorough knowledge of this chapter
before you proceed to configure the NATs, Filters, etc.
PART V - ROUTING PROTOCOLS
The aim of this part is to get the most out of addressing and routing. The routing
function moves data through the network efficiently and finds new paths when
network changes occur. Routing also affects how large the network can grow -
that is, the complexity of the topology and the stability of the network as it
expands. All the chapters in this part focus on configuring the routing services.
Chapter 23 “Protocol Independent Features” lists the protocol independent
commands that are generic across all routing protocols. You are required to have
a thorough knowledge of this chapter before you proceed to configure the RIP,
OSPF and BGP.
Chapter 24 “Router Information Protocol” and Chapter 25 “Border Gateway
Protocol” and Chapter 26 “Open Shortest Path First” provides configuration
commands for configuring RIP, OSPF and BGP routing protocols.
Chapter 27 “Multicast Routing” provides Multicast routing configuration on the
OmniAccess 5740 USG.
Chapter 28 “Policy Based Routing” covers the commands for Policy Based
Routing (PBR) configuration on the OmniAccess 5740 USG.
Chapter 29 “Virtual Routing and Forwarding” covers the CLI commands for
configuring Virtual Routing and Forwarding Customer Edge on OmniAccess 5740
USG.
To Next Page
Loading...
