Using the Command Line Interface
Left running head:
Chapter name (automatic)
16
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
U
SER MODE (UM)
You can start the CLI session from a console, SSH or a Telnet connection. When
you start the CLI session, you are prompted for a user name/password
combination. When you enter the user name and the password correctly, you will
automatically enter the UM. (When you start the CLI session for the very first time,
you will be prompted to enter the superadmin password.)
For remote logins, if you enter an incorrect password three consecutive times, the
CLI session will be closed.
Since UM is the basic administrative level, only a limited set of commands like
basic diagnostics, monitoring commands, ping, and SSH are available. The UM
command set is a subset of the SUM command set. UM is also the starting point
for accessing the SUM command set.
U
SER MODE COMMAND SET
Command (in UM) Description
clear Reset functions
enable Turn on privileged commands
exit Exit from current mode
help Description of the interactive help system
logout Exit from the EXEC
mping Multicast Ping
mtrace Trace reverse multicast path from destination to
source
no Negate a command or set its defaults
nslookup Translate a DNS name to an IP address or vice-
versa
ping Send echo messages
quit Quit this session
service Set terminal line parameters
show Show running system information
ssh Open a SSH connection
telnet Open a telnet connection
terminal Set terminal line parameters
traceroute Trace route to destination
To Next Page
Loading...
Need help?
General
