Introduction to CLI Modes
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
19
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CONFIGURATION MODE (CM)
To enter Configuration Mode, enter "configure terminal" command from the Super
User Mode. This mode allows you to configure system related configuration or
modify running system configuration. If you later save the configuration, these
commands are stored across router reboots. To access CM, enter the following
command in SUM:
E
XAMPLE
ALU#configure terminal
ALU(config)#
Enter configuration commands, one per line. End with CNTL/Z.
To exit the Configuration Mode and return to the SUM, enter the Control-Z
command.
ALU(config)#^Z
ALU#
CM C
OMMAND SET
Command (in SUM) Description
configure terminal Enters Configuration Mode
Command (in CM) Description
aaa Authentication, Authorization, and
Accounting
access-list Add an access list entry
arp ARP setting
auto Create Auto-QoS template
card Line Card Configuration
certificate Certificate to perform encryption and
decryption of https connections.
change Change a dialer list rule's line number
class-map Set QoS Class Map.
clear Terminating the Session
clock System clock settings
controller Select a controller to configure
crypto IPSEC VPN module
customized-service Customize services
To Next Page
Loading...
Need help?
General
