Texas Instruments TM4C1294NCPDT - Page 1400

DescriptionResetTypeNameBit/Field
Use Acceptance Mask
DescriptionValue
Mask is ignored.0
Use mask (MSK, MXTD, and MDIR bits in the
CANIFnMSKn registers) for acceptance filtering.
1
0RWUMASK12
Transmit Interrupt Enable
DescriptionValue
The INTPND bit in the CANIFnMCTL register is unchanged
after a successful transmission of a frame.
0
The INTPND bit in the CANIFnMCTL register is set after
a successful transmission of a frame.
1
0RWTXIE11
Receive Interrupt Enable
DescriptionValue
The INTPND bit in the CANIFnMCTL register is unchanged
after a successful reception of a frame.
0
The INTPND bit in the CANIFnMCTL register is set after
a successful reception of a frame.
1
0RWRXIE10
Remote Enable
DescriptionValue
At the reception of a remote frame, the TXRQST bit in the
CANIFnMCTL register is left unchanged.
0
At the reception of a remote frame, the TXRQST bit in the
CANIFnMCTL register is set.
1
0RWRMTEN9
Transmit Request
DescriptionValue
This message object is not waiting for transmission.0
The transmission of this message object is requested
and is not yet done.
1
Note: If the WRNRD and TXRQST bits in the CANIFnCMSK register
are set, this bit is ignored.
0RWTXRQST8
June 18, 20141400
Texas Instruments-Production Data
Controller Area Network (CAN) Module