DescriptionResetTypeNameBit/Field
Interrupt Enable
DescriptionValue
Interrupt generation is disabled. Software can use the
COUNT bit to determine if the counter has ever reached 0.
0
An interrupt is generated to the NVIC when SysTick counts
to 0.
1
0RWINTEN1
Enable
DescriptionValue
The counter is disabled.0
Enables SysTick to operate in a multi-shot way. That is, the
counter loads the RELOAD value and begins counting down.
On reaching 0, the COUNT bit is set and an interrupt is
generated if enabled by INTEN. The counter then loads the
RELOAD value again and begins counting.
1
0RWENABLE0
151June 18, 2014
Texas Instruments-Production Data
Tiva
™
TM4C1294NCPDT Microcontroller
To Next Page
Loading...
