Texas Instruments TM4C1294NCPDT - Table 27-64. Peripheral Current Consumption

d. Note that if the MOSC is the source of the Run-mode system clock and is powered down in Sleep mode, wake time is increased by
T
MOSC_SETTLE
.
e. To achieve the lowest possible Deep-Sleep current, one or more wait states must be configured in the MEMTIM0 register. If there are
no wait states applied in Run mode, then lowest possible Deep-Sleep current is not achieved.
f. See the section called “LDO Power Control” on page 244 for information on lowering the LDO voltage to 0.9 V.
Table 27-64. Peripheral Current Consumption
UnitsNomSystem ClockConditionsParameter NameParameter
mA4.0120 MHz (MOSC with
PLL)
V
DD
= 3.3 V
V
DDA
= 3.3 V
USB (including USB PHY) run
mode current
I
DDUSB
mA30120 MHz (MOSC with
PLL)
V
DD
= 3.3 V
V
DDA
= 3.3 V
Ethernet MAC and PHY run
mode current
I
DDEMACPHY
June 18, 20141884
Texas Instruments-Production Data
Electrical Characteristics