Register 64: PWM0 Fault Source 0 (PWM0FLTSRC0), offset 0x074
Register 65: PWM1 Fault Source 0 (PWM1FLTSRC0), offset 0x0B4
Register 66: PWM2 Fault Source 0 (PWM2FLTSRC0), offset 0x0F4
Register 67: PWM3 Fault Source 0 (PWM3FLTSRC0), offset 0x134
This register specifies which fault pin inputs are used to generate a fault condition. Each bit in the
following register indicates whether the corresponding fault pin is included in the fault condition. All
enabled fault pins are ORed together to form the PWMnFLTSRC0 portion of the fault condition.
The PWMnFLTSRC0 fault condition is then ORed with the PWMnFLTSRC1 fault condition to
generate the final fault condition for the PWM generator.
If the FLTSRC bit in the PWMnCTL register (see page 1708) is clear, only the Fault0 signal affects
the fault condition generated. Otherwise, sources defined in PWMnFLTSRC0 and PWMnFLTSRC1
affect the fault condition generated.
PWMn Fault Source 0 (PWMnFLTSRC0)
PWM0 base: 0x4002.8000
Offset 0x074
Type RW, reset 0x0000.0000
16171819202122232425262728293031
reserved
ROROROROROROROROROROROROROROROROType
0000000000000000Reset
0123456789101112131415
FAULT0FAULT1FAULT2FAULT3reserved
RWRWRWRWROROROROROROROROROROROROType
0000000000000000Reset
DescriptionResetTypeNameBit/Field
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0ROreserved31:4
Fault3 Input
DescriptionValue
The Fault3 signal is suppressed and cannot generate a fault
condition.
0
The Fault3 signal value is ORed with all other fault condition
generation inputs (Faultn signals and digital comparators).
1
Note: The FLTSRC bit in the PWMnCTL register must be set for this
bit to affect fault condition generation.
0RWFAULT33
1733June 18, 2014
Texas Instruments-Production Data
Tiva
™
TM4C1294NCPDT Microcontroller
To Next Page
Loading...
Need help?
General
