Register 72: EPI Software Reset (SREPI), offset 0x510
The SREPI register provides software the capability to reset the available EPI module.
A peripheral is reset by software using a simple two-step process:
1. Software sets a bit (or bits) in the SREPI register. While the SREPI bit is 1, the peripheral is
held in reset.
2. Software completes the reset process by clearing the SREPI bit.
There may be latency from the clearing of the SREPI bit to when the peripheral is ready for use.
Software should check the corresponding PREPI bit to verify that the EPI Module registers are ready
to be accessed.
Important: This register should be used to reset the EPI module.
EPI Software Reset (SREPI)
Base 0x400F.E000
Offset 0x510
Type RW, reset 0x0000.0000
16171819202122232425262728293031
reserved
ROROROROROROROROROROROROROROROROType
0000000000000000Reset
0123456789101112131415
R0reserved
RWROROROROROROROROROROROROROROROType
0000000000000000Reset
DescriptionResetTypeNameBit/Field
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0ROreserved31:1
EPI Module Software Reset
DescriptionValue
EPI module is not reset.0
EPI module is reset.1
0RWR00
361June 18, 2014
Texas Instruments-Production Data
Tiva
™
TM4C1294NCPDT Microcontroller
To Next Page
Loading...
Need help?
General
