DescriptionResetTypeNameBit/Field
Isolate MII outputs when Enhanced Link is not Achievable
DescriptionValue
Normal MII outputs operation0
When no link established in 100B-TX and Full Duplex conditions,
MII outputs are tied low.
1
0RWISOMIILL3
Detection of Receive Symbol Error During IDLE State
DescriptionValue
Disable detection of Receive symbol error during IDLE state.0
Enable detection of Receive symbol error during IDLE state.1
1RWRXERRIDLE2
Detection of Transmit Error
DescriptionValue
Enable detection of deassertion of the internal transmit enable
on an odd-nibble boundary. In this case the internal transmit
enable is extended by one additional transmit clock cycle and
behaves as if the internal transmit error was asserted during
that additional cycle.
0
Disable detection of internal transmit error in odd-nibble
boundary.
1
0RWODDNDETDIS1
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0ROreserved0
June 18, 20141610
Texas Instruments-Production Data
Ethernet Controller
To Next Page
Loading...
Need help?
General
