DescriptionResetTypeNameBit/Field
FAULT1 Interrupt Asserted
DescriptionValue
The fault condition for PWM generator 1 has not been asserted
or is not enabled.
0
An enabled interrupt for the fault condition for PWM generator
1 is asserted or is latched.
1
Writing a 1 to this bit clears it and the INTFAULT1 bit in the PWMRIS
register.
0RW1CINTFAULT117
FAULT0 Interrupt Asserted
DescriptionValue
The fault condition for PWM generator 0 has not been asserted
or is not enabled.
0
An enabled interrupt for the fault condition for PWM generator
0 is asserted or is latched.
1
Writing a 1 to this bit clears it and the INTFAULT0 bit in the PWMRIS
register.
0RW1CINTFAULT016
Software should not rely on the value of a reserved bit. To provide
compatibility with future products, the value of a reserved bit should be
preserved across a read-modify-write operation.
0x000ROreserved15:4
PWM3 Interrupt Status
DescriptionValue
The PWM generator 3 block interrupt is not asserted or is not
enabled.
0
An enabled interrupt for the PWM generator 3 block is asserted.1
The PWM3RIS register shows the source of this interrupt. This bit is
cleared by writing a 1 to the corresponding bit in the PWM3ISC register.
0ROINTPWM33
PWM2 Interrupt Status
DescriptionValue
The PWM generator 2 block interrupt is not asserted or is not
enabled.
0
An enabled interrupt for the PWM generator 2 block is asserted.1
The PWM2RIS register shows the source of this interrupt. This bit is
cleared by writing a 1 to the corresponding bit in the PWM2ISC register.
0ROINTPWM22
PWM1 Interrupt Status
DescriptionValue
The PWM generator 1 block interrupt is not asserted or is not
enabled.
0
An enabled interrupt for the PWM generator 1 block is asserted.1
The PWM1RIS register shows the source of this interrupt. This bit is
cleared by writing a 1 to the corresponding bit in the PWM1ISC register.
0ROINTPWM11
June 18, 20141698
Texas Instruments-Production Data
Pulse Width Modulator (PWM)
To Next Page
Loading...
Need help?
General
