DescriptionResetTypeNameBit/Field
CS3n Host Bus Sub-Mode
This field determines which Host Bus 8 sub-mode to use for CS3n in
multiple chip select mode. Sub-mode use is determined by the connected
external peripheral. See Table 11-8 on page 831 for information on how
this bit field affects the operation of the EPI signals.
Note: The CSBAUD bit must be set to enable this CS3n MODE field.
If CSBAUD is clear, all chip-selects use the MODE configuration
defined in the EPIHB8CFG register.
DescriptionValue
ADMUX – AD[7:0]
Data and Address are muxed.
0x0
ADNONMUX – D[7:0]
Data and address are separate.
0x1
reserved0x2-0x3
0x0RWMODE1:0
June 18, 2014924
Texas Instruments-Production Data
External Peripheral Interface (EPI)
To Next Page
Loading...
Need help?
General
