Table 26-3. Signals by Signal Name (continued)
DescriptionBuffer TypePin TypePin Mux / Pin
Assignment
Pin NumberPin Name
USB data 1.TTLI/OPL1 (14)82USB0D1
USB data 2.TTLI/OPL2 (14)83USB0D2
USB data 3.TTLI/OPL3 (14)84USB0D3
USB data 4.TTLI/OPL4 (14)85USB0D4
USB data 5.TTLI/OPL5 (14)86USB0D5
USB data 6.TTLI/OPP5 (14)106USB0D6
USB data 7.TTLI/OPP4 (14)105USB0D7
Indicates that the external PHY is able to accept
data from the USB controller.
TTLOPP3 (14)104USB0DIR
Bidirectional differential data pin (D- per USB
specification) for USB0.
AnalogI/OPL793USB0DM
Bidirectional differential data pin (D+ per USB
specification) for USB0.
AnalogI/OPL694USB0DP
Optionally used in Host mode to control an external
power source to supply power to the USB bus.
TTLOPA6 (5)
PA7 (11)
PD6 (5)
40
41
127
USB0EPEN
This signal senses the state of the USB ID signal.
The USB PHY enables an integrated pull-up, and
an external element (USB connector) indicates the
initial state of the USB controller (pulled down is
the A side of the cable and pulled up is the B side).
AnalogIPB095USB0ID
Asserted by the external PHY to throttle all data
types.
TTLOPP2 (14)103USB0NXT
Optionally used in Host mode by an external power
source to indicate an error state by that power
source.
TTLIPA7 (5)
PD7 (5)
41
128
USB0PFLT
Asserted by the USB controller to signal the end of
a USB transmit packet or register write operation.
TTLOPB2 (14)91USB0STP
This signal is used during the session request
protocol. This signal allows the USB PHY to both
sense the voltage level of VBUS, and pull up VBUS
momentarily during VBUS pulsing.
AnalogI/OPB196USB0VBUS
Power source for the Hibernation module. It is
normally connected to the positive terminal of a
battery and serves as the battery
backup/Hibernation module power-source supply.
Power-fixed68VBAT
Positive supply for I/O and some logic.Power-fixed7
16
26
28
39
47
51
52
69
79
90
101
113
122
VDD
1795June 18, 2014
Texas Instruments-Production Data
Tiva
™
TM4C1294NCPDT Microcontroller
To Next Page
Loading...
Need help?
General
