DescriptionResetTypeNameBit/Field
GPTM Timer A Match Raw Interrupt
DescriptionValue
The match value has not been reached.0
The TAMIE bit is set in the GPTMTAMR register, and the match
value in the GPTMTAMATCHR and (optionally) GPTMTAPMR
registers have been reached when configured in one-shot or
periodic mode.
1
This bit is cleared by writing a 1 to the TAMCINT bit in the GPTMICR
register.
0ROTAMRIS4
GPTM RTC Raw Interrupt
DescriptionValue
The RTC event has not occurred.0
The RTC event has occurred.1
This bit is cleared by writing a 1 to the RTCCINT bit in the GPTMICR
register.
0RORTCRIS3
GPTM Timer A Capture Mode Event Raw Interrupt
DescriptionValue
The capture mode event for Timer A has not occurred.0
A capture mode event has occurred for Timer A. This interrupt
asserts when the subtimer is configured in Input Edge-Time
mode.
1
This bit is cleared by writing a 1 to the CAECINT bit in the GPTMICR
register.
0ROCAERIS2
GPTM Timer A Capture Mode Match Raw Interrupt
DescriptionValue
The capture mode match for Timer A has not occurred.0
A capture mode match has occurred for Timer A. This interrupt
asserts when the values in the GPTMTAR and GPTMTAPR
match the values in the GPTMTAMATCHR and GPTMTAPMR
when configured in Input Edge-Time mode.
1
This bit is cleared by writing a 1 to the CAMCINT bit in the GPTMICR
register.
0ROCAMRIS1
GPTM Timer A Time-Out Raw Interrupt
DescriptionValue
Timer A has not timed out.0
Timer A has timed out. This interrupt is asserted when a
one-shot or periodic mode timer reaches it's count limit (0 or
the value loaded into GPTMTAILR, depending on the count
direction).
1
This bit is cleared by writing a 1 to the TATOCINT bit in the GPTMICR
register.
0ROTATORIS0
June 18, 2014998
Texas Instruments-Production Data
General-Purpose Timers
To Next Page
Loading...
Need help?
General
