Texas Instruments AFE79 Series User Manual

List of Macros www.ti.com
100
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Macro
Table 1-43. (continued)
Error Status Registers Interpretation
Error Code 2 (32-bit) If RX DDC Configuration is in error
Bit[11:0]: RESERVED
Bit[12]: ‘1’ → Interface rate for 1RX does not support dual band configuration
Bit[13]: ‘1’ → Interface rate for 2RX does not support dual band configuration
Bit[14]: ‘1’ → Interface rate for 3RX does not support dual band configuration
Bit[15]: ‘1’ → Interface rate for 4RX does not support dual band configuration
Bit[19:16] → RESERVED
Bit[20]: ‘1’ → ADC Rate, Interface Rate Combination for 1RX is not supported
Bit[21]: ‘1’ → ADC Rate, Interface Rate Combination for 2RX is not supported
Bit[22]: ‘1’ → ADC Rate, Interface Rate Combination for 3RX is not supported
Bit[23]: ‘1’ → ADC Rate, Interface Rate Combination for 4RX is not supported
Bit[31:24]: RESERVED
If FB DDC Configuration is in error
Bit[1:0]: RESERVED
Bit[2]: ‘1’ → ADC Rate, Interface Rate Combination for 1FB is not supported
Bit[3]: ‘1’ → ADC Rate, Interface Rate Combination for 2FB is not supported
If TX DUC Configuration is in error Bit[3:0]: RESERVED
Bit[4]: ‘1’ → Configuration requested for 1TX is not supported
Bit[5]: ‘1’ → Configuration requested for 2TX is not supported
Bit[6]: ‘1’ → Configuration requested for 3TX is not supported
Bit[7]: ‘1’ → Configuration requested for 4TX is not supported
Bit[31:8] → Reserved
1.2.2.2 Apply DSA Gain-Phase Compensation Macro
This macro configures the RX/TX DSA Gain-Phase calibration parameters by parsing through the
calibration packet which should be loaded in MACRO_MEMORY prior to calling this macro.
Table 1-44.
Macro Apply DSA-GP factory calibration data
Opcode 0x11
Operand Offset Length Value Functionality Results
1 0x00 1 Calibration Appl.
Choice
0 → Treat the
packet loaded in
memory as TX-DSA
Gain Phase
Calibration Packet
and program the
calibration
parameters.
1 → Treat the
packet loaded in
memory as RX-DSA
Gain Phase
Calibration Packet
and program the
calibration
parameters
Memory DSA Calibration Packet
1.2.2.2.1 Error Reporting
Table 1-45.
Error Status Registers Interpretation
Error Code 1 (16-bit) 0 → NO_ERROR
1 → RESERVED
2 → PKT_CHECKSUM_FAILED: Checksum check on loaded
packet failed
>2 → RESERVED

Texas Instruments AFE79 Series Specifications

General

Brand	Texas Instruments
Model	AFE79 Series
Category	Control Unit
Language	English