www.ti.com
FB Top Register Map
945
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.14.284 Register 5D4h (offset = 5D4h) [reset = 0h]
Figure 2-2167. Register 5D4h
7 6 5 4 3 2 1 0
FB_AGC_DIG_DET_NUM_HITS_SEEN[7:0]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2181. Register 5D4 Field Descriptions
Bit Field Type Reset Description
7-0
FB_AGC_DIG_DE
T_NUM_HITS_SE
EN[7:0]
R 0h
Indicates Number of Hits observed. Based on
dig_det_read_sel the corresponding digital peak detector
status is read. This will get updated only when update pulse is
given.. Running accum mode should not be used when
interpreting this.
2.14.285 Register 5D5h (offset = 5D5h) [reset = 0h]
Figure 2-2168. Register 5D5h
7 6 5 4 3 2 1 0
FB_AGC_DIG_DET_NUM_HITS_SEEN[15:8]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2182. Register 5D5 Field Descriptions
Bit Field Type Reset Description
7-0
FB_AGC_DIG_DE
T_NUM_HITS_SE
EN[15:8]
R 0h
Indicates Number of Hits observed. Based on
dig_det_read_sel the corresponding digital peak detector
status is read. This will get updated only when update pulse is
given.. Running accum mode should not be used when
interpreting this.
2.14.286 Register 5D6h (offset = 5D6h) [reset = 0h]
Figure 2-2169. Register 5D6h
7 6 5 4 3 2 1 0
FB_AGC_DIG_DET_NUM_HITS_SEEN[23:16]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2183. Register 5D6 Field Descriptions
Bit Field Type Reset Description
7-0
FB_AGC_DIG_DE
T_NUM_HITS_SE
EN[23:16]
R 0h
Indicates Number of Hits observed. Based on
dig_det_read_sel the corresponding digital peak detector
status is read. This will get updated only when update pulse is
given.. Running accum mode should not be used when
interpreting this.
To Next Page
Loading...
