Texas Instruments AFE79 Series - 2.16.185 Register 2 F5 h (offset = 2 F5 h) [reset = 2 h]; 2.16.186 Register 2 F6 h (offset = 2 F6 h) [reset = 0 h]; 2.16.187 Register 2 F8 h (offset = 2 F8 h) [reset = 1 h]

www.ti.com IO Wrap Register Map
1051
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-2463. Register 2F4 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_61
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.185 Register 2F5h (offset = 2F5h) [reset = 2h]
Figure 2-2448. Register 2F5h
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_61
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2464. Register 2F5 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_6
1
R/W 2h Input buffer signal strength
2.16.186 Register 2F6h (offset = 2F6h) [reset = 0h]
Figure 2-2449. Register 2F6h
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_61
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2465. Register 2F6 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
61
R/W 0h output buffer drive strength.
2.16.187 Register 2F8h (offset = 2F8h) [reset = 1h]
Figure 2-2450. Register 2F8h
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_62
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2466. Register 2F8 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_62
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.