Texas Instruments AFE79 Series - 2.16.52 Register 244 h (offset = 244 h) [reset = 1 h]; 2.16.53 Register 245 h (offset = 245 h) [reset = 2 h]; 2.16.54 Register 246 h (offset = 246 h) [reset = 0 h]

www.ti.com IO Wrap Register Map
1013
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-2330. Register 242 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
16
R/W 0h output buffer drive strength.
2.16.52 Register 244h (offset = 244h) [reset = 1h]
Figure 2-2315. Register 244h
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_17
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2331. Register 244 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_17
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.53 Register 245h (offset = 245h) [reset = 2h]
Figure 2-2316. Register 245h
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_17
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2332. Register 245 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_1
7
R/W 2h Input buffer signal strength
2.16.54 Register 246h (offset = 246h) [reset = 0h]
Figure 2-2317. Register 246h
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_17
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2333. Register 246 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
17
R/W 0h output buffer drive strength.