Texas Instruments AFE79 Series - 2.16.604 Register 10 BCh (offset = 10 BCh) [reset = 0 h]; 2.16.605 Register 10 BDh (offset = 10 BDh) [reset = 2 h]; 2.16.606 Register 10 C0 h (offset = 10 C0 h) [reset = 0 h]

www.ti.com IO Wrap Register Map
1199
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.16.604 Register 10BCh (offset = 10BCh) [reset = 0h]
Figure 2-2867. Register 10BCh
7 6 5 4 3 2 1 0
POL_INTPO_A
LARM_1
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2883. Register 10BC Field Descriptions
Bit Field Type Reset Description
0-0
POL_INTPO_ALAR
M_1
R/W 0h
polarity control for intpo_alarm_1. 0 indicates pass through
from GPIO when selected 1 indicates inverted signal
2.16.605 Register 10BDh (offset = 10BDh) [reset = 2h]
Figure 2-2868. Register 10BDh
7 6 5 4 3 2 1 0
OVR_SEL_INT
PO_ALARM_1
OVR_INTPO_A
LARM_1
R/W-1h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2884. Register 10BD Field Descriptions
Bit Field Type Reset Description
1-1
OVR_SEL_INTPO_
ALARM_1
R/W 1h
control to select whether the input function intpo_alarm_1
needs to be overriden ot not. 1 indicates override.
0-0
OVR_INTPO_ALA
RM_1
R/W 0h
override value for intpo_alarm_1 when ovr_sel_intpo_alarm_1
is made high
2.16.606 Register 10C0h (offset = 10C0h) [reset = 0h]
Figure 2-2869. Register 10C0h
7 6 5 4 3 2 1 0
POL_INTPO_A
LARM_2
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2885. Register 10C0 Field Descriptions
Bit Field Type Reset Description
0-0
POL_INTPO_ALAR
M_2
R/W 0h
polarity control for intpo_alarm_2. 0 indicates pass through
from GPIO when selected 1 indicates inverted signal