Texas Instruments AFE79 Series - 2.10.62 Register 212 h (offset = 212 h) [reset = 0 h]; 2.10.63 Register 213 h (offset = 213 h) [reset = 0 h]; 2.10.64 Register 214 h (offset = 214 h) [reset = 0 h]

DSA Page 1 Register Map www.ti.com
612
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-1177. Register 211 Field Descriptions
Bit Field Type Reset Description
0-0 MASK_DIG0_TXB R/W 0h Mask Change Pulse generation for diggain0.
2.10.62 Register 212h (offset = 212h) [reset = 0h]
Figure 2-1168. Register 212h
7 6 5 4 3 2 1 0
MASK_DIG1_T
XB
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1178. Register 212 Field Descriptions
Bit Field Type Reset Description
0-0 MASK_DIG1_TXB R/W 0h Mask Change Pulse generation for diggain1.
2.10.63 Register 213h (offset = 213h) [reset = 0h]
Figure 2-1169. Register 213h
7 6 5 4 3 2 1 0
USE_SYNC_T
RIG_B
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1179. Register 213 Field Descriptions
Bit Field Type Reset Description
0-0
USE_SYNC_TRIG
_B
R/W 0h
If this is set only writing to the TxB causes the Change Pulses
generation.
2.10.64 Register 214h (offset = 214h) [reset = 0h]
Figure 2-1170. Register 214h
7 6 5 4 3 2 1 0
TXB_SW0_FINE TXB_DSA_INDEX_SWAP0
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1180. Register 214 Field Descriptions
Bit Field Type Reset Description
7-6 TXB_SW0_FINE R/W 0h Fine gain value for TxB during swap select of 01.
5-0
TXB_DSA_INDEX_
SWAP0
R/W 0h TxB DSA value during swap select of 01.