Texas Instruments AFE79 Series - 2.16.73 Register 260 h (offset = 260 h) [reset = 1 h]; 2.16.74 Register 261 h (offset = 261 h) [reset = 2 h]; 2.16.75 Register 262 h (offset = 262 h) [reset = 0 h]

www.ti.com IO Wrap Register Map
1019
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-2351. Register 25E Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
23
R/W 0h output buffer drive strength.
2.16.73 Register 260h (offset = 260h) [reset = 1h]
Figure 2-2336. Register 260h
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_24
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2352. Register 260 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_24
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.74 Register 261h (offset = 261h) [reset = 2h]
Figure 2-2337. Register 261h
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_24
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2353. Register 261 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_2
4
R/W 2h
Input buffer signal strength
Unused as this is fixed IO
2.16.75 Register 262h (offset = 262h) [reset = 0h]
Figure 2-2338. Register 262h
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_24
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2354. Register 262 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
24
R/W 0h
output buffer drive strength.
Unused as this is fixed IO