JESD_SUBCHIP Register Map
www.ti.com
198
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-110. Register 7A Field Descriptions (continued)
Bit Field Type Reset Description
3-0
BIT_MASKDIS_RX
C
R/W 0h
To disable gating in RxC data of the below mentioned LSBS
when RxC is OFF since these LSBs might carry OVR data
0001 - LSB0
0010 - LSB1
0100 - LSB4
1000 - LSB5
2.3.67 Register 7Bh (offset = 7Bh) [reset = 0h]
Figure 2-108. Register 7Bh
7 6 5 4 3 2 1 0
BIT_MASKDIS_FBCD BIT_MASKDIS_FBAB
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-111. Register 7B Field Descriptions
Bit Field Type Reset Description
7-4
BIT_MASKDIS_FB
CD
R/W 0h
To disable gating in FBCD data of the below mentioned LSBS
when FBCD is OFF since these LSBs might carry OVR data
0001 - LSB0
0010 - LSB1
0100 - LSB4
1000 - LSB5
3-0
BIT_MASKDIS_FB
AB
R/W 0h
To disable gating in FB A data of the below mentioned LSBS
when FBAB is OFF since these LSBs might carry OVR data
0001 - LSB0
0010 - LSB1
0100 - LSB4
1000 - LSB5
2.3.68 Register 7Ch (offset = 7Ch) [reset = C3h]
Figure 2-109. Register 7Ch
7 6 5 4 3 2 1 0
LP_RX_ON_B_SEL_2R1F_AB_MASK LP_RX_ON_A_SEL_2R1F_AB_MASK
R/W-Ch R/W-3h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-112. Register 7C Field Descriptions
Bit Field Type Reset Description
7-4
LP_RX_ON_B_SE
L_2R1F_AB_MAS
K
R/W Ch
FOR LOW POWER CONSUMPTION:
Its a bit mask, used to compute sig-valid as a combination of
rx_on d,c,b,a.Used to gate 4 streams of 16b data i.e. output of
4R mux for 2R1F_AB inst. So, based on the data mux
settings, this mask should be chosen.
1111 - Uses ored rx_on d,c,b,a
0111 - Uses or'ed rx_on c,b,a
0011 - Uses or'ed rx_on b,a
0001 - Uses or'ed rx_on a
0000 - Uses zero