Texas Instruments AFE79 Series - 2.8.33 Register C0 h (offset = C0 h) [reset = 0 h]; 2.8.34 Register C1 h (offset = C1 h) [reset = 0 h]; 2.8.35 Register C2 h (offset = C2 h) [reset = 0 h]

Macro Register Map www.ti.com
550
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-971. Register BF Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG7[31:24]
R/W 0h
Macro operand register # 7. Interpretation of the operand(s) in
this register are dependent on MACRO_OPCODE
2.8.33 Register C0h (offset = C0h) [reset = 0h]
Figure 2-964. Register C0h
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG8[7:0]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-972. Register C0 Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG8[7:0]
R/W 0h
Macro operand register # 8. Interpretation of the operand(s) in
this register are dependent on MACRO_OPCODE
2.8.34 Register C1h (offset = C1h) [reset = 0h]
Figure 2-965. Register C1h
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG8[15:8]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-973. Register C1 Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG8[15:8]
R/W 0h
Macro operand register # 8. Interpretation of the operand(s) in
this register are dependent on MACRO_OPCODE
2.8.35 Register C2h (offset = C2h) [reset = 0h]
Figure 2-966. Register C2h
7 6 5 4 3 2 1 0
MACRO_OPERAND_REG8[23:16]
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-974. Register C2 Field Descriptions
Bit Field Type Reset Description
7-0
MACRO_OPERAN
D_REG8[23:16]
R/W 0h
Macro operand register # 8. Interpretation of the operand(s) in
this register are dependent on MACRO_OPCODE