Texas Instruments AFE79 Series - 2.12.122 Register 526 h (offset = 526 h) [reset = 0 h]; 2.12.123 Register 528 h (offset = 528 h) [reset = 0 h]; 2.12.124 Register 52 Ch (offset = 52 Ch) [reset = 0 h]

www.ti.com TX Top Register Map
671
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-1336. Register 525 Field Descriptions
Bit Field Type Reset Description
0-0
TX_PAP_DUAL_B
AND_SINGLE_BA
ND_EN
R/W 0h
Enable for PAP dual/single band detectors.
0:Disable:
1:Enable:
2.12.122 Register 526h (offset = 526h) [reset = 0h]
Figure 2-1325. Register 526h
7 6 5 4 3 2 1 0
TX_PAP_SINGLE_BAND_DUAL
_BAND_DISABLE
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1337. Register 526 Field Descriptions
Bit Field Type Reset Description
1-0
TX_PAP_SINGLE_
BAND_DUAL_BAN
D_DISABLE
R/W 0h
Disable PA protection for one of the bands when PAP
detectors are in run in dual band mode
0:Enable both bands:
1:Disable band0 only:
2:Disable band1 only:
3:Disable both bands:
2.12.123 Register 528h (offset = 528h) [reset = 0h]
Figure 2-1326. Register 528h
7 6 5 4 3 2 1 0
TX_PAP_MAS
TER_EN
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1338. Register 528 Field Descriptions
Bit Field Type Reset Description
0-0
TX_PAP_MASTER
_EN
R/W 0h
Enable PAP blocks. This is Master enable, which enables
PAP for dual/single band detectors, Dual band combiner
detectors, Multiplier and control logic (PAP trigger and FSM)
0 : Disable
1 : Enable
2.12.124 Register 52Ch (offset = 52Ch) [reset = 0h]
Figure 2-1327. Register 52Ch
7 6 5 4 3 2 1 0
TX_PAP_ALARM_CLR
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset