Texas Instruments AFE79 Series - 2.10.51 Register 1 C1 h (offset = 1 C1 h) [reset = 0 h]; 2.10.52 Register 1 C2 h (offset = 1 C2 h) [reset = 0 h]; 2.10.53 Register 1 C3 h (offset = 1 C3 h) [reset = 0 h]; 2.10.54 Register 1 C4 h (offset = 1 C4 h) [reset = 0 h]

www.ti.com DSA Page 1 Register Map
609
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
2.10.51 Register 1C1h (offset = 1C1h) [reset = 0h]
Figure 2-1157. Register 1C1h
7 6 5 4 3 2 1 0
MASK_DIG0_T
XA
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1167. Register 1C1 Field Descriptions
Bit Field Type Reset Description
0-0 MASK_DIG0_TXA R/W 0h Mask change pulse generation with diggain0.
2.10.52 Register 1C2h (offset = 1C2h) [reset = 0h]
Figure 2-1158. Register 1C2h
7 6 5 4 3 2 1 0
MASK_DIG1_T
XA
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1168. Register 1C2 Field Descriptions
Bit Field Type Reset Description
0-0 MASK_DIG1_TXA R/W 0h Mask change pulse generation with diggain1.
2.10.53 Register 1C3h (offset = 1C3h) [reset = 0h]
Figure 2-1159. Register 1C3h
7 6 5 4 3 2 1 0
USE_SYNC_T
RIG_A
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1169. Register 1C3 Field Descriptions
Bit Field Type Reset Description
0-0
USE_SYNC_TRIG
_A
R/W 0h
If this bit is set, Only writing to the TxA will cause the Change
Pulses for both TxA and TxB. This will be the behavior in
normal mode as well as swap modes.
2.10.54 Register 1C4h (offset = 1C4h) [reset = 0h]
Figure 2-1160. Register 1C4h
7 6 5 4 3 2 1 0
TXA_SW0_FINE TXA_DSA_INDEX_SWAP0
R/W-0h R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset