Texas Instruments AFE79 Series - 2.16.220 Register 324 h (offset = 324 h) [reset = 1 h]; 2.16.221 Register 325 h (offset = 325 h) [reset = 2 h]; 2.16.222 Register 326 h (offset = 326 h) [reset = 0 h]

www.ti.com IO Wrap Register Map
1061
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-2498. Register 322 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
72
R/W 0h output buffer drive strength.
2.16.220 Register 324h (offset = 324h) [reset = 1h]
Figure 2-2483. Register 324h
7 6 5 4 3 2 1 0
PULL_CTRL_GPIO_73
R/W-1h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2499. Register 324 Field Descriptions
Bit Field Type Reset Description
2-0
PULL_CTRL_GPIO
_73
R/W 1h
Bit 0 indicates Pull up enable.
Bit <1> Indicates Pull value.
Bit <2> is unused.
2.16.221 Register 325h (offset = 325h) [reset = 2h]
Figure 2-2484. Register 325h
7 6 5 4 3 2 1 0
IBUF_ST_GPIO_73
R/W-2h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2500. Register 325 Field Descriptions
Bit Field Type Reset Description
1-0
IBUF_ST_GPIO_7
3
R/W 2h Input buffer signal strength
2.16.222 Register 326h (offset = 326h) [reset = 0h]
Figure 2-2485. Register 326h
7 6 5 4 3 2 1 0
ODRIV_DS_GPIO_73
R/W-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-2501. Register 326 Field Descriptions
Bit Field Type Reset Description
1-0
ODRIV_DS_GPIO_
73
R/W 0h output buffer drive strength.