Texas Instruments AFE79 Series - 2.11.8 Register 107 h (offset = 107 h) [reset = 80 h]; 2.11.9 Register 10 Ch (offset = 10 Ch) [reset = 0 h]; 2.11.10 Register 110 h (offset = 110 h) [reset = 0 h]

Digital Top Register Map www.ti.com
618
SBAU337–May 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Serial Interface Register Maps
Table 2-1193. Register 106 Field Descriptions
Bit Field Type Reset Description
7-0
ALARM_MASK_M
SB_FOR_ALARM1
[7:0]
R/W 0h
Mask bits for alarm condition of MSB(last-16 )alarm condtions.
A high value at a bit position indicates the corresponding
alarm condition is not used in the final alarm generation.
There are two alarms (0,1) and this one correspond to alarm1.
Bit0 to Bit7 -> 0
2.11.8 Register 107h (offset = 107h) [reset = 80h]
Figure 2-1183. Register 107h
7 6 5 4 3 2 1 0
ALARM_MASK_MSB_FOR_ALARM1[15:8]
R/W-80h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1194. Register 107 Field Descriptions
Bit Field Type Reset Description
7-0
ALARM_MASK_M
SB_FOR_ALARM1
[15:8]
R/W 80h
Mask bits for alarm condition of MSB(last-16 )alarm condtions.
A high value at a bit position indicates the corresponding
alarm condition is not used in the final alarm generation.
There are two alarms (0,1) and this one correspond to alarm1.
Bit8 to Bit15 -> 0.
2.11.9 Register 10Ch (offset = 10Ch) [reset = 0h]
Figure 2-1184. Register 10Ch
7 6 5 4 3 2 1 0
SPIREAD_ALARM
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1195. Register 10C Field Descriptions
Bit Field Type Reset Description
1-0 SPIREAD_ALARM R 0h bit0 reads Alarm0, bit1 reads Alarm1 as a register.
2.11.10 Register 110h (offset = 110h) [reset = 0h]
Figure 2-1185. Register 110h
7 6 5 4 3 2 1 0
SPI_READ_ALARM_PREMASK[7:0]
R-0h
LEGEND: R/W = Read/Write; W = Write only; -n = value after reset
Table 2-1196. Register 110 Field Descriptions
Bit Field Type Reset Description
7-0
SPI_READ_ALAR
M_PREMASK[7:0]
R 0h Reads the value of 32 alarms prior to mask.